Eradicator Gen II O
3
Manual Supplement
Install & Service Guide
9
Copyright ©2021 Aqua Systems, All Rights Reserved • 404 Moravian Valley Road, Waunakee, WI 53597
Gen II O
3
with Ozone
4.
5.
Green wire
to Relay 1
Meter wire
Power
wire
Drive Motor
wire
Installation
Push the EOG II harness through the strain relief slot that the
power cord went through. Pull through about 10” of the harness.
Then make sure the wire is fully seated in the strain relief slot.
Reinstall the drive bracket (step 2) and the circuit board (step 1)
in the reverse order of removal.
Connect the power, meter, and drive motor harnesses to the
circuit board as illustrated. Then connect the relay wire
(green wire) to the relay block in the Relay 1 port and tighten
the set screw until secure.
Harness to
EOG II Box
Q 101 . 10
T
MO
OR
SET
CLOCK
NEXT
REGEN
DOWN
UP
DP SW
RLY2 COM RLY1
METER
J8 OUTPUT
M
ETER
COMM
CABLE
12 VAC
A
L
T
MTR
AUX
MA
V
