Hefter TF MEGA-A, Инструкция по эксплуатации, Страница: 40 / 71

3-10
Chapter3 Advanced Operation
Table of Stacker Rollers Position (North America)
Stacker Rollers
Position
Length of Folded Paper (C) Folding Mode
1 7.0 to 8.5 inches LD: single fold, irregular accordion fold (fold out), gate fold
Single folded paper larger than LD
2 6.0 to 7.0 inches LG: Irregular accordion fold (fold out), gate fold
3 5.0 to 6.0 inches LT: single fold, irregular accordion fold (fold out) gate fold
LD: letter fold, accordion fold (Z fold)
4 4.0 to 5.0 inches LG: letter fold, accordion fold (Z fold)
LD: double fold
5 1.6 to 4.0 inches LT: double fold, letter fold, accordion fold (Z fold)
LG: double fold
10
Press the key for test folding and
check if the paper is ejected smoothly.
If mis-feed or double-feed occurs, refer to
Chapter2 "Basic Operation" “1.Standard
Folding of Standard Paper” "1-3. Operation
Procedures ( p.2-2).
11
If the paper is not ejected smoothly,
change the position of the stacker
rollers again.
Folded sample
12
Check the finish of test folding.
Check for folding misalignment using the
second test folded sample.
If folding misalignments occur, refer to
Chapter 3 "ADVANCED OPERATION"“5.
Correcting Folding Misalignment”
( p3-20).
13
After completing adjustments, set the
count mode either to the add count or
to the subtract count, then press the
key to start folding operations.
Refer to Chapter2 "Basic Operation"
“1.Standard Folding of Standard Paper” "1-3.
Operation Procedures ( p2-2).