hecht 6285 Xl, Оригинальная инструкция по эксплуатации

Страница: 20 / 24

20 / 68
CS
EN
SK
PL
HU
2. Remove the objects blocking the shredder and clean the inside of the housing if necessary.
3. Close the housing cover and secure by tightening the knob.
TROUBLESHOOTING
PROBLEM POSSIBLE CaUSE SOLUTIOn
Machine fails to
operate
Securing konb has not been
fully tightened
Tighten securing konb
Power turned off Turn power on
Mains socket faulty Check the socket
Extension cable damaged Inspect cable, replace if damaged
The material to
be shredded is
no pulled in
Material to be shredded is
too soft
Use the prodder or add dry branches
Jammed material in the ma-
chine
Clear jammed material
Excessive vibra-
tion / noise
Blade bolt loose Tighten blade bolt
Cutting blade damaged Replace blade
Meachine damaged internally
Have checked by authorized service cen-
ter
WaRnInG! Defects that can not be repaired using this table, can only be
corrected by an authorized service center.
SERVICE AND SPARE PARTS
•
Have your device serviced by a qualified repair personnel using only identical replacement parts.
This will ensure that the safety of the device is maintained.
•
Whether you need technical advice, repair, or genuine factory replacement parts, contact the
WERCO authorized service nearest you. Information on service locations, visit
www.hecht.cz
• When ordering spare parts, please quote the part number, this can be found at www.hecht.cz
DISPOSAL
•
Dispose your device, accessories and packaging in accordance with the requirements of
environmental protection into the recycling collection center.
•
This machine does not belong to the household waste. Save the environment and take this
device to designated collection points where it will be received for free. For more information
please contact your local authority or nearest collection point. Improper disposal may be
punished according to national regulations.
GUARANTEE OF THE PRODUCT