Heatilator GNDC30, Инструкция по установке и эксплуатации

Страница: 20 / 28

28467 Rev I 20 02-02
NOVUS TOP DV GAS APPLIANCE INSTALLATION INSTRUCTIONS
2. STANDING PILOT
FOR YOUR SAFETY
READ BEFORE OPERATING
A. This gas appliance has a manual ignition device that lights the pilot. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob to light the pilot. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it - call a qualified service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use the appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been
under water.
LIGHTING INSTRUCTIONS
STOP! READ THE SAFETY INFORMATION ABOVE ON THIS LABEL!
TO TURN OFF GAS TO APPLIANCE
1. Turn wall switch to the “OFF” position or set
thermostat to lowest setting.
2. Open the control access panel.
3. Turn manual shutoff valve to “CLOSED”. Wait five
minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP!
Follow “B” in the safety information above on this
label. If you don’t smell gas, go to the next step.
4. Turn manual shutoff valve to “OPEN”.
5. Turn pilot knob clockwise to “OFF”. Knob may have
to be depressed to pass the “PILOT” position.
6. Locate pilot assembly inside the appliance.
7. Locate red ignitor button.
8. Turn pilot knob to “PILOT” and push in.
9. Continue to hold in pilot knob and push the red
ignitor button 12-15 times until small blue pilot flame
appears.
10. Continue to hold in pilot knob for approximately one
minute. Pilot should remain lit. If pilot goes out, wait
five minutes and repeat Steps 4-9.
11. Release and turn the knob counterclockwise to “ON”.
To light main burner, turn wall switch to “ON”. Do not
light by hand.
12. If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance” and call
your service technician or gas supplier.
1. Turn off the wall switch or set the thermostat to
the lowest setting.
2. Open the control access panel.
3. Turn the manual shutoff valve to the “CLOSED”
position. Do not force.
4. Close the control access panel.
WARNING!
If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
All manuals and user guides at all-guides.com