02-02
17
28467 Rev I
NOVUS TOP DV GAS APPLIANCE INSTALLATION INSTRUCTIONS
G. FINISHING
H. APPLIANCE PREPARATION
Figure 31
Finishing Materials
WARNING!
Grilles on this appliance cannot, in any way, be
covered as it may create a fire hazard.
1. COMBUSTIBLE FINISHING MATERIAL
Material made of or surfaced with wood, compressed
paper, plant fibers, plastics, or any material capable
of igniting and burning, whether flame proofed or not,
plastered or unplastered (this includes drywall).
2. NONCOMBUSTIBLE FINISHING
MATERIAL
Material which will not ignite and burn. Such materials
are those consisting entirely of steel, iron, brick, tile,
concrete, slate, glass or plasters, or combination
thereof, or have a UL Fire rating of zero.
3. HIGH TEMPERATURE SEALANT
MATERIAL
Sealants that will withstand high temperatures;
General Electric RTV103 (Black), or equivalent.
Rutland, Inc. Appliance Mortar #63, or equivalent.
A high temperature sealant, 1/8 inch wide minimum,
must be used to close off gaps between the appliance
and facing to prevent cold air leaks. See Figure 31.
1. ATTACHING THE HOOD
The hood is to be located above the glass panel. The hood must be attached or a fire hazard may result. Locate the
four screws just inside the upper section of the appliance. Position the hood and slide into position. Tighten the four
screws. See Figure 32.
2. UPPER GRILLE PANEL REMOVAL
Grasp the upper grille panel and remove the rubber pins holding the grille. See Figure 33.
3. CONTROL ACCESS PANEL REMOVAL
Release the spring pin on the right hand side of the control access panel. See Figure 34.
4. GLASS AND SCREEN REMOVAL
See page 24 of this manual.
Figure 32 - Installing the Hood
Figure 33 - Upper Grille Panel Removal
All manuals and user guides at all-guides.com
