Heatilator GNDC30, Инструкция по установке и эксплуатации

Страница: 19 / 28

02-02 19 28467 Rev I
NOVUS TOP DV GAS APPLIANCE INSTALLATION INSTRUCTIONS
FOR YOUR SAFETY
READ BEFORE OPERATING
A. This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in and move the gas control lever or turn the gas control knob.
Never use tools. If the lever or knob will not move by hand, don’t try to repair it--call a qualified service
technician.
Forced or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been
under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above on this label.
2. Turn wall switch to the “OFF” position.
3. This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light
burner by hand.
4. Wait five (5) minutes to clear out any gas. If you then smell gas. STOP! Follow “B “ in the safety information
above on this label. If you don’t smell gas, go on to the next step.
5. To turn on burner, turn on the wall switch.
6. If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO APPLIANCE” and call your
service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Turn off the wall switch.
2. Turn gas line to the “OFF” position.
3. Close control access panel.
I. DETERMINING THE IGNITION TYPE
To determine whether your appliance is an electronic
ignition or a standing pilot ignition, open the control
access panel to examine the wiring system. If your system
has a red ignitor button (as shown in Figure 39), you own
a standing pilot ignition appliance. If no red ignitor button
is present, you have an electronic ignition appliance.
You may also check the rating label located on the inside
of the control access panel to determine ignition type.
Figure 39 - Standing Pilot Ignition
1. ELECTRONIC IGNITION APPLIANCES
WARNING! If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
J. LIGHTING INSTRUCTIONS
All manuals and user guides at all-guides.com