HBM TIM40, Инструкция по монтажу

Страница: 5 / 58

Safety instructions
TIM40
A02590_04_E00_00 HBM: public
5
1 Safety instructions
Appropriate use
The TIM40 torque interface module is used exclusively for torque measure­
ment tasks in combination with the T40 torque flange and control and adjust­
ment tasks directly connected thereto. Use for any additional purpose shall be
deemed to be
not as intended.
In the interests of safety, the module should only be operated as described in
the mounting instructions. It is also essential to comply with the legal and
safety requirements for the application concerned during use. The same
applies to the use of accessories.
The interface module is not a safety element within the meaning of its use as
intended. Proper and safe operation of this transducer requires proper trans­
portation, correct storage, assembly and mounting and careful operation.
Each time, before starting up the module, you must first run a project planning
and risk analysis that takes into account all the safety aspects of automation
technology. This particularly concerns personal and machine protection.
Additional safety precautions must be taken in plants where malfunctions could
cause major damage, loss of data or even personal injury. In the event of a
fault, these precautions establish safe operating conditions.
Safety rules
The device must be operated with a separated extra-low voltage (18...30 V DC
supply voltage).
Before commissioning, make sure that the mains voltage and type of current
match the mains voltage and type of current at the place of operation and that
the circuit used is sufficiently protected. Connecting electrical devices to low
voltage: to separated extra-low voltage only (safety isolating transformer ac­
cording to DINVDE 0551/EN60742). Do not operate the device if the mains
lead is damaged. Only operate built-in devices once they are installed in the
housing provided. The device complies with the safety requirements of
DIN EN 61010 Part 1 (VDE 0411 - Part 1); protection class I.