HBM TIM40, Инструкция по монтажу

Страница: 6 / 58

Safety instructions
6
A02590_04_E00_00 HBM: public
TIM40
The device must be mounted on a support rail connected to protective ground
potential. Both the support rail and the device must be free of paint, varnish
and dirt at the point of installation.
The supply connection, as well as the signal and sense leads, must be
installed in such a way that electromagnetic interference does not adversely
affect device functionality (HBM recommendation: ”Greenline shielding design”,
downloadable from the Internet at
http://www.hbm.com/hbmdoc/amplifiers/
brochures ).
Automation equipment and devices must be covered over in such a way that
adequate protection or locking against unintentional actuation is provided (such
as access checks, password protection, etc.).
When devices are working in a network, these networks must be designed in
such a way that malfunctions in individual nodes can be detected and shut
down.
Safety precautions must be taken both in terms of hardware and software, so
that a line break or other interruptions to signal transmission, such as via the
bus interfaces, do not cause undefined states or loss of data in the automation
device.
General dangers of failing to follow the safety instructions
The TIM40 Module is a state of the art device and as such is failsafe. The
module may give rise to further dangers if it is inappropriately installed and
operated by untrained personnel. Any person instructed to carry out installa­
tion, commissioning, maintenance or repair of the module must have read and
understood the mounting Instructions and in particular the technical safety in­
structions.
Conditions on site
Protect the module from direct contact with water (protection class IP20).
Maintenance and cleaning
The modules are maintenance‐free. Please note the following when cleaning
the housing:
S
Before cleaning, disconnect the equipment completely.