HBM TEDS, Руководство по эксплуатации

Страница: 18 / 36

18
TEDS
A1813-1.1 en HBM
HBM template:
Freqsensor:
Physical and electrical units are specified before a template is created by the
manufacturer. In addition, a selection must be made during creation between
the variants ”Frequency” or ”Counter”.
It must also be specified which resolution should be used: 24 Bit, 16 Bit or 8
Bit.
Parameters Value Unit Chang
e re-
quires
rights
to
level:
Explanation
Transducer electrical Signal
Type
Pulse Sensor ID
Minimum Velocity 0.000E+000 rpm CAL Physical Measurement pa-
rameters and units are de-
Maximum Velocity 1.000E+004 rpm CAL
rameters and units are de
fined when the template is
created
Pulse Measurement Type Frequency CAL Measuring mode frequency
measurement or pulse
counting
Minimum Electrical Value 0.0 Hz CAL The difference between
these values is the sensi-
tivity according to the HBM
Maximum Electrical Value 60000.0 Hz CAL
tivity according to the HBM
data sheet, the HBM test
certificate or from calibra-
tion.
Mapping Method Linear Cannot be changed
Discrete Signal Type Bipolar Input mode:
Contact to ground,
Contact to Power,
Discrete Signal Amplitude 4 Volts
Active Low,
Active High,
Bipolar
Discrete Signal Configuration single Evaluation F2 signal;
Single
Double 90 degree
Double phase plus zero
index
Transducer Response Time 1.0000000u seconds Of no significance for HBM
transducers.