HBM Genesis ISOBE5600, Руководство пользователя

Страница: 119 / 128

D Locations for AC Calibration Adjustments
D.1 Introduction
This section describes how to open the ISOBE5600 for calibration and
adjustment.
To make adjustments to the AC calibration of the ISOBE5600 you will need:
l
Cable: CBL/6600 HV ID AC CAL PWR
l
Nylon Adjustment screw: TOOL CERAMIC ADJUSTER
Opening the Isolated Digitizers
1
Turn of the unit by using the power switch and remove the power cord when
using the ISOBE5600tm Isolated Digitizers.
2 Remove rubber protectors at each end of the Isolated digitizer.
3 Only when working with the ISOBE5600t use a flat head screw driver to
remove the battery screw (1 fixed "captive" screw for each battery).
Pull out the batteries from the casings using the battery handle.
4
Remove the two (top) black plastic cross
-
head fasteners and plugs at each
end of the Isolated Digitizer outer casing.
5 Remove the blue casing lid to reveal the metal battery housing.
6 Carefully lift
-
out the metal battery/power supply casing.
Note This might be difficult! at one end of the casing is a connector pin and plug
assembly which you will have to pull apart.
7 Plug in the supplied cable accessory (CBL/6600 HV ID AC CAL PWR), from
the digitizer
-
base to the bottom of the battery/power supply fixture.
8
Only when working with the ISOBE5600t re
-
Insert the removed battery/
batteries into the battery
-
casing.
9 Connect the optical fibre communication lead and the power cord when
using the ISOBE5600tm Isolated Digitizers.
10 Turn on the unit using the power switch.
WARNING
The orientation of the battery should be such that the battery pins connect
with the battery
-
casing plug inside the fixture.
Only use HBM approved batteries to avoid damaging the unit.
ISOBE5600
I2716-4.0 en 119