Haulotte HA20RTJ O, Руководство оператора

Страница: 61 / 112

A
B
C
D
E
F
G
H
I
61 4000388880 E 06 15 GB / USA
C
- Pre-operation inspection
HA20RTJ - HA20RTJ O - HA20RTJ PRO - HA61RTJ O - HA61RTJ PRO
4.2 - A
CTIVATION OF CONTROLS
The enable switch must be active to allow all movements.
The "Enable Switch" system depends on the machine configuration and will consist of one of
the following :
• Joystick trigger at platform box (if fitted).
• Foot pedal switch in the basket.
• Enable switch at ground box.
4.3 - F
AULT DETECTOR
The machine is equipped with an on-board fault detection system, which indicates the type of
fault to the operator.
The fault is identified by a default code.
The default code is dispalyed at the ground control box.
According to the type of fault, the machine MAY switch into DOWNGRADEMODE and certain
movements are prevented to maintain Operator's safety.
Do not use the machine until the fault has been corrected.
4.3.1 - Indicators/LED's test
F r o m t h e g r o u n d c o n t r o l b o x
F r o m t h e p l a t f o r m c o n t r o l b o x
4.3.2 - Buzzers test
F r o m t h e g r o u n d c o n t r o l b o x
Step Action
1 Pull both the E-Stop buttons ( 46 ) at platform box and ( 15 ) at ground box.
2 Set the ON/OFF key switch ( 18 ) to ON position.
3 Check that the LED's ( 1 - 10 ) light up on the display box.
4 Check that the LED's on the display are all turned off after 1 sec.
Step Action
1 Pull E-Stop button ( 15 ) at ground panel.
2 Turn the ON/OFF key switch ( 18 ) at ground box to ON position.
3 Turn the energizing selector switch ( 229 ) to the left to energize platform control box.
4 First push in the E-Stop button ( 46 ) at platform box, then pull out.
5 Check that the LED's ( 101 - 117 ) light up on the platform display panel.
6 Check that the LED's ( 101 - 117 ) on the display are all turned off after 1 sec.
Step Action
1 Pull both E-Stop buttons ( 15 ) at ground box and ( 46 ) at platform box.
2 Set the ON/OFF key switch ( 18 ) to ON position.
3 Buzzers at ground and platform will beep.