Haulotte HA20RTJ O, Руководство оператора

Страница: 60 / 112

60 4000388880 E 06 15 GB / USA
HA20RTJ - HA20RTJ O - HA20RTJ PRO - HA61RTJ O - HA61RTJ PRO
C
- Pre-operation inspection
4 - Safety functional checks
To protect the user and the machine, safety systems prevent the movement of the machine beyond its
operating limits. These safety systems when activated immobilize the machine and prevent further
movement.
The operator must be familiar with this technology and understand that is not a malfunction but an
indication that the machine has reached an operation limit.
Aerial Work platforms are equipped with two control boxes which allow operators to safely use the
machine. An auxiliary device (overriding system) is available on ground control box when primary
power source fails. Each control box is equipped with an E-Stop button, which cuts all movements
when pushed in.
The following checks describe the operation of the machine and the specific controls required.
For the location and description of these controls : refer to section B 3.2 and D 2 Ground control
box and B 3.3 and D 3 Platform control box.
4.1 - E-S
TOP BUTTON CHECK
G r o u n d c o n t r o l b o x E - s t o p b u t t o n
P l a t f o r m c o n t r o l b o x E - s t o p b u t t o n
Step Action
1 Pull both E-Stop buttons ( 15 ) at ground box and ( 46 ) at platform box.
2 Set the ON/OFF key switch ( 18 ) at ground box to the ON position.
3
Turn the selector switch ( 229 ) knob to the right to energize the ground control box. LED's ( 1 - 10 ) on
the display will light up.
4 Start the engine by moving the enable/auxiliary power switch ( 228 ) upwards.
5 Push the E-stop button ( 15 ).
6 Check that the engine stops running.
7 No movements are functional.
Step Action
1 Pull out the E-Stop button ( 15 ) at ground box.
2 Set the ON/OFF key switch ( 18 ) at ground box to the ON position.
3 Turn the selector switch knob ( 229 ) at ground box to the left to energize platform box.
4 Pull out the E-Stop button ( 46 ) at platform panel.
5 Start the engine from platform using Start/Stop switch ( 230 ).
6 Push in E-Stop button ( 46 ) at platform.
7 Check that the engine stops running.
8 No movements are functional.