Haulotte Group xlb-4725a, Руководство по техническому обслуживанию оператора, Страница: 39 / 118

HAULOTTE GROUP 4 EQUIPMENT MAINTENANCE
39
BATTERY RECHARGE (CONTINUED)

If a Battery fault is detected, a fault code will appear on the
CHARGE CURRENT
display. The red
CHECK BATTERY
indicator LED will become lit. Refer to Table 4-1 for battery charger fault codes.

When the battery charge reaches 80% of capacity, the yellow “ 80%
CHARGED
” indicator LED will
become lit and the “
GREEN CHARGING
” indicator LED will begin to flash.

When the batteries have reached a full charge, the green and yellow indicator LED s will turn
themselves off. CC (Charge Complete) will appear on the
CHARGE CURRENT
display. After two
hours, this display will fade and the
CHARGE CURRENT
will read 00.

Unplug the
EXTENSION CORD
from the outlet and the charger receptacle on the aerial work
platform. Store the
EXTENSION CORD
for next use.
BATTERY FAULT CODES
TABLE 4-1. BATTERY CHARGER FAULT CODES
Code Description Limits Cause
F0 No Battery <10 volts Loose connection or battery missing
F1 Over Voltage >112% charge voltage Connected to wrong battery voltage
F2 Over Current >60 amperes Operating machine while charging
F3 Bulk Mode Timeout <80% charge at 16 hrs. Battery fault
F4 ARD Mode Timeout >80% and <full charge
after 6 hrs Max. Battery fault
F9 Current Measurement
Error Standby
Board fault or charger exposed to
extreme cold
FA Triac Error Board shorted
FF Full Power to
Transformer, No
Current Output Battery shorted or low AC line voltage
or charge fault
CO Charger Off Charger resting between pulses
(AGM batteries only)
CC Charge Mode Complete Batteries charged
WARNING
DO NOT disconnect any output leads or connectors
between the batteries and the charger when the charger
is on. To stop a charge in progress, always unplug the
extension cord from the AC Power source.
NOTICE
Always unplug the battery charger power cord before
moving the aerial work platform. Failure to disconnect
power cord could cause damage to the equipment
.