Haulotte Group xlb-4725a, Руководство по техническому обслуживанию оператора, Страница: 11 / 118

HAULOTTE GROUP 1 SAFETY
11
DURING OPERATION (CONTINUED
)
NEVER exceed load ratings by transferring loads to the aerial work platform at elevated heights.
NEVER use the platform to lift a load that exceeds the platform dimensions. NEVER lift a load in
such a way that the center of gravity is higher than the top guardrail of the platform.
NEVER modify the platform or carry materials that would increase the surface area of the platform.
Increasing the area exposed to the wind may affect the aerial work platform stability. NEVER attach
overhanging loads when raising or lowering the platform.
NEVER use the boom or platform to push or pull or to lift any part of the machine.
NEVER use the boom or platform to place a load against any structure, materials or equipment.
NEVER climb on the boom.
NEVER leave an elevated platform unattended.
NEVER leave the keys in the aerial work platform while unattended or not in use.
DRIVE SAFETY
ALWAYS maintain an awareness of limited sight and blind spots when operating drive functions.
ALWAYS limit travel speed according to surface conditions, slope, location of personnel and
obstructions and any other factors which may result in collision.
NEVER operate drive functions on slopes exceeding 45% (24°).
NEVER engage in stunt driving, horseplay or any other behavior considered unsafe according to
employer, job site and all Federal, State, and Local codes and regulations.
NEVER operate the internal combustion engine in an area that is not properly ventilated.
NEVER fuel the internal combustion engine while smoking, or while near spark or open flame.
FALL PROTECTION

Occupants must wear a safety belt or harness in accordance
with all Federal, State, and Local codes and regulations. Attach
lanyard to the anchor provided on the work platform.

Never sit, stand, or climb on the platform guard rails. Maintain
a firm footing on the platform floor at all times.

Never climb down from the platform when raised. If a power
failure should occur, ground personnel should use the manual
controls to lower the platform. Refer to the “Operation” section
of this manual for manual operation.

Keep platform floor clear of debris.

Lower the platform entry mid-rail or close the entry gate before
operating
.