13 |
P a g e
End Loop Handrail Assembly
1.
With handrails completed along both sides of
the ramp run, you can now install any end
loops specified by your application drawing.
2.
Begin end loop installation by installing
connection sleeves into end loop. Use
predrilled holes and provided self-tapping
screws.
3.
With connection sleeves secured to end loop,
install handrail starter bracket on the lower tube
of the end loop. Use predrilled holes to determine
orientation. The predrilled holes will face down to
the ground once installed to the ramp handrail.
4.
Finish installation by sliding the exposed connection sleeve into ramp
handrail. While holding the joint tight, install provided self-tapping screw
through predrilled hole in the upper rail. With the upper connection
completed, secure handrail starter bracket into handrail with 2 self-tapping
screws. Install remaining screws to complete the connection.
Installing handrail starter bracket to handrail before making the upper
connection will typically result in an unsatisfactory joint between end
loop and handrail.
04OCT19 | 630-00103-01 Rev B
