10 |
P a g e
Ramp Run Assembly
1.
Attach J-hook to the upper landing using the appropriate fasteners. The
upper landing may be an existing structure or a Harmar platform.
2.
Installation Method 1:
a.
Install first section of ramp into J-Hook
and then attach leg brackets with legs. It
is helpful to rest the bottom end of the
ramp section on top of something while
mounting the brackets/legs. Lift ramp
section to appropriate height and
tighten both brackets and both legs.
b.
Level ramp section from side to side and
securely tighten fasteners. Leaving one
side a bit loose will make sliding in the
next ramp section much easier but you
must go back and tighten.
c.
Confirm slope is consistent and of
appropriate grade.
d.
Repeat steps A-C for each additional section
of ramp. Before installing the last section of
ramp, slide the transition plate into the
bottom side groove. Avoid getting dirt or
contaminants into connection.
TIP: Load leg into bracket before
attaching to ramp section.
04OCT19 | 630-00103-01 Rev B
