Harman Martin ELP WW, Руководство пользователя

Страница: 9 / 36

Martin® ELP WW User Manual 9
Physical installation
Warning! Read ‘Safety information’ on page 4 before installing the fixture.
Warning! The safety and suitability of lifting equipment, installation location,
anchoring method, mounting hardware and electrical installation are the
responsibility of the installer. All local safety regulations and legal requirements must
be observed when installing and connecting the fixture. Installation must be carried
out by qualified professionals only.
Contact your Martin supplier for assistance if you have any questions about how to install this
product safely.
Fixture location
The ELP Profile fixture is intended for interior use only. Do not install outside or in wet or humid
locations. The fixture requires free and unobstructed airflow around it to ensure adequate cooling.
Observe the following limitations in selecting a location:
•
Respect the precautions listed under Safety information’ on page 4.
•
Do not locate the fixture in an unventilated space.
Warning! See drawing on right. Lenses
can focus sunlight and strong light,
presenting a risk of fire and damage to
the fixture, creating a potential fire
hazard and causing damage. Position
or shade the head so that the front lens
will not be exposed to sunlight or
another strong light source from any
angle – even for a few seconds.
Important! Do not point the output from other lighting fixtures at the fixture, as powerful light can
damage the display.
Mounting the fixture
Warning! All fasteners used to mount ELP Profile fixtures must be strong enough to
hold the fixture safely. Install a washer directly under the head of each fastener when
anchoring the mounting bracket to the installation surface.
Fastening the fixture to a flat surface
The fixture can be fastened to a hard, fixed, flat surface in any orientation. Ensure that the surface
and all fasteners used can support at least 10 times the weight of all fixtures and equipment they
will support.
Fasten the fixture securely. Do not stand it on a surface where it may fall over. If you install the
fixture in a location where it may cause injury or damage if it falls, secure it as directed below with
a securely anchored, approved safety cable that will hold the fixture if the primary fastening
method fails.
Mounting the fixture on a truss
The fixture can be clamped to a truss or similar rigging structure in any
orientation. Use a suitable rigging clamp such as a G-clamp or a half-coupler
clamp (see illustration on right) fastened to the mounting yoke.
To clamp the fixture to a truss:
1. Check that the rigging structure can support at least 10 times the weight
of all fixtures and equipment to be installed on it.