Harman Martin ELP WW, Руководство пользователя

Страница: 15 / 36

Martin® ELP WW User Manual 15
For independent control, each fixture must be assigned its own control channels. Two fixtures of
the same type may share the same address if identical behavior is desired. Address sharing can
be useful for diagnostic purposes and symmetric control.
To set the fixture’s DMX address:
1.
Enter the control menu and select DMX SETUP. Press ENTER.
2. Select DMX ADDRESS and press ENTER.
3. Use the UP and DOWN buttons to select the desired address setting.
4. Press ENTER to confirm your selection (or to return to the top-level menu without changing the
settings, press the MENU button).
Setting DMX personality
DMX personality sets how many control channels are used. There are 3 personalities to choose
from:
•
1 channel – Dimmer only
•
2 channel – 8-bit dimmer with adjustment of dimmer fade times
•
4 channel – 16-bit dimmer with shutter and adjustment of dimmer fade times
(4-channel is the default mode)
The commands available on each channel are described in the section “DMX protocol” on page 24.
To set the DMX personality:
1.
Enter the control menu and select DMX SETUP. Press ENTER.
2. Select DMX MODE and press ENTER.
3. Use the UP and DOWN buttons to select 1, 2 or 4.
4. Press ENTER to confirm your selection (or to return to the top level menu without changing the
settings, press the MENU button).
Other fixture settings
The PERSONALITY menu allows you to set other options for the fixture.
Stand-alone mode
The fixture can operate in stand-alone mode allowing control of multiple fixtures from a single
master fixture if no DMX console is connected. The options are OFF (default), MASTER and
CLIENT
. Stand-alone operation will be automatically overridden by incoming DMX signal.
Dimming curves
Four dimming modes are available:
LINEAR The increase in light intensity appears to be linear as DMX value is
increased.
SQUARE LAW light intensity control is finer at low levels and coarser at high levels.
INV SQ LAW (Inverse square law) light intensity control is coarser at low levels and finer
at high levels.
S-CURVE light intensity control is finer at low levels and high levels and coarser at
medium levels.