Harman Martin ELP WW, Руководство пользователя, Страница: 17 / 36

Martin® ELP WW User Manual 17
Press ENTER to confirm (or press MENU to exit without making a change).
Fixture Test
This menu allows you to run self-test sequences on the fixture’s LED emitters. A sequence of LED
test, dimmer test, strobe test will be run.
Fixture information
The INFORMATION menu allows you to view various fixture information: Power on time, LED
hours, Software version, Fixture ID, RDM unique ID, Fan speeds, temperatures.
Viewing live DMX values
This menu allows you to view the current DMX values for any function.
Select the DMX LIVE menu and press ENTER.
Use the UP and DOWN buttons to select the function you wish to view.
Setting control values manually
You can manually set control values. This may be useful when testing, or to use the fixture in a
static setting without a DMX controller.
This menu also allows you to reset the fixture.
Reset
To reset the fixture, go to the MANUAL CONTROL menu and press ENTER. Use the UP and
DOWN buttons to select RESET and press ENTER again.
Then use UP and DOWN to select YES, and press ENTER to activate.
Setting values
Go to the MANUAL CONTROL menu and press ENTER. Use the UP and DOWN buttons to select
the function you wish to control.
Once you have selected a function, press ENTER, then use the UP and DOWN buttons to select a
value from 0 to 255.
Press MENU to go back up and select a different function to control.
Calibration
From the SERVICE menu you can select CALIBRATION. This menu allows you to adjust the
overall brightness of the fixture to match with other fixtures. The fixture is calibrated in the factory
but over time the brightness of the LED emitters will gradually decrease, so this function can be
useful if you need to match a new fixture with older ones.
•
DIMMER sets the overall maximum brightness of the fixture.
•
WHITE (available from firmware v. 1.2) gives fine adjustment of the fixture’s color temperature.
•
LOAD DEF will load the factory-set calibration values. If you have replaced the factory-set
values with custom values using SAVE SET (see below) it will load the custom values.
•
SAVE SET replaces the factory-set DIMMER and WHITE values with any custom values that
have currently been set.
You must enter a password (019 by default) before you can access the SAVE SET menu item.
Important! The SAVE SET command permanently overwrites the factory-set calibration values. It
is not possible to restore the factory-set values by powering the fixture off and on, resetting the
fixture or uploading new firmware. Once you have saved custom calibration values using SAVE
SET, the only way to return to the original factory-set values is to re-adjust the DIMMER and
WHITE calibration settings back to their original values.