Harman Martin ELP WW, Руководство пользователя, Страница: 6 / 36

6 Martin® ELP WW User Manual
Do not attempt to bypass thermostatic switches or fuses.
Do not modify the fixture in any way not described in this manual or install other than
genuine Martin parts. Do not stick filters, masks or other materials onto any lens or
other optical component. Use only accessories approved by Martin to modify the
light beam.
Protection from eye injury
To minimize the risk of eye irritation or injury, disconnect the fixture from power at all
times when the fixture is not in use, and provide well-lit conditions to reduce the pupil
diameter of anyone working on or near the fixture.
The light from the LED emitters is possibly hazardous and may be harmful to the
eyes. Do not stare directly into the product’s light output.
Do not look at the light output with magnifiers, telescopes, binoculars or similar
optical instruments that may concentrate the light output.
Ensure that persons are not looking directly into the fixture when the product lights
up suddenly. This can happen when power is applied, when the product receives a
DMX signal, or when certain control menu items are selected.
Protection from injury
Fasten the fixture securely to a fixed surface or structure when in use. The fixture is
not portable when installed.
Ensure that all supporting structures, surfaces, fasteners and lifting equipment can
bear the weight of all the devices they are intended to support plus an adequate
safety margin, and that they conform to local building and safety regulations.
If the fixture is installed in a location where it may cause injury or damage if it falls,
install as described in this manual a secondary attachment such as a safety cable
that is approved by an official body such as TÜV as a safety attachment for the
weight that it secures. The safety cable must comply with EN 60598-2-17 Section
17.6.6 or BGV C1 / DGUV 17, and must be capable of bearing a static suspended
load at least six times (or more if required by locally applicable regulations) the
weight that it secures.
Eliminate as much slack as possible in the safety cable (by looping it more than once
around the rigging truss, for example). Make sure that, if the primary attachment
fails, the fixture cannot fall more than 20 cm (8 inches) maximum before the safety
cable catches it.
If the safety cable attachment point becomes deformed, do not suspend the fixture.
Have the fixture repaired by an authorized Martin service partner.
Ensure that any accessory such as gel frames, gobo holders is securely fastened.
Block access below the work area and work from a stable platform whenever
installing, setting, adjusting, or cleaning the fixture.
Do not operate the fixture with missing or damaged covers, shields or any optical
component.
If an operating problem occurs, stop using the fixture immediately and disconnect it
from power. Do not attempt to use a fixture that is obviously damaged.