Harman Martin Atomic 3000 LED, Руководство пользователя

Страница: 9 / 44

AC power 9
AC power
Warning! Read “Safety Information” on page 3 before connecting the Atomic 3000 LED to AC mains
power.
Warning! For protection from electric shock, the Atomic 3000 LED must be grounded (earthed). The
power distribution circuit must be equipped with a fuse or circuit breaker and ground-fault
(earth-fault) protection.
Warning! Socket outlets or external power switches used to supply the Atomic 3000 LED with power
must be located near the fixture and easily accessible so that the fixtures can easily be
disconnected from power.
Important! Do not use an external dimming system to supply power to the Atomic 3000 LED, as this
may cause damage to the fixture that is not covered by the product warranty.
Power voltage
Warning! Check that the voltage range specified on the fixture’s serial number label
matches the local AC mains power voltage before applying power to the fixture.
The Atomic 3000 LED has an auto-ranging power supply that accepts mains power at 100 - 240 VAC
nominal, 50/60 Hz. Do not apply AC mains power at any other voltage or frequency to the fixture.
The Atomic 3000 LED can draw significant peak currents during normal use. To avoid overload, allow one
16 or 20 amp branch circuit per fixture to operate at full power. Two fixtures may be placed on a 16 amp
branch circuit, but considerations for the type of MCB (Miniature Circuit Breaker) must also be respected: 16
A type C will fit most needs (IEC 60898 / UL489 / CSA C22.2 No. 5).
Power cables and power plug
The Atomic 3000 LED power input cable must meet the requirements listed under “Protection from electric
shock” on page 3. The power input cable must have a Neutrik PowerCON TRUE1 NAC3FX-W cable
connector for AC mains power input to the fixture. Keep cable runs as short as possible.
If you need to install a Neutrik PowerCON TRUE1 connector on a power cable, see the instructions from
Neutrik that are reproduced at the end of this manual.
You can hard-wire the Atomic 3000 LED to a building electrical installation if you want to install it
permanently, or you can install on the power cable a power plug that is suitable for the local AC power
outlets.
If you install a power plug on the power cable for connection to an AC power outlet, install a grounding-type
(earthed) plug with an integral cable grip that is rated 250 V, 20 A minimum. In the EU the plug must be
rated 250 V, 16 A minimum. Follow the plug manufacturer’s instructions. Table 1 shows standard wire
color-coding schemes and some possible pin identification schemes; if pins are not clearly identified, or if
you have any doubts about proper installation, consult a qualified electrician.
Wire Color
(EU models) Wire Color
(US models) Conductor Symbol Screw (US)
brown black live L yellow or brass
blue white neutral N silver
yellow/green green ground (earth) or green
Table 1: Wire color-coding and power connections