Reference Manual - JPK-1300
17
PC Tool Control
Controlling the JPK-1300 through the PC tool.
Download the “AMX Jetpack Manager” from amx.com and install this application tool on the PC. Before
launching this tool, connect all the JPK-1300 kits and the PC into the same network.
The default IP mode of JPK-1300 is DHCP. If there is no DHCP server in the network, the default IP of JPK-1300 is 192.168.1.2. The IP addresses of
all the kits in the same network can be discovered by the PC tool.
Launch AMX Jetpack Manager and select “DISCOVER” in the menu on the top.
Discover
The Discover page is used to discover devices and set device PIN code.
The PIN code is a string of 8 digits. (The default PIN code is 00000000.)
New PIN code can be applied on each device. To discover devices with multiple PIN codes, please separate multiple PIN codes with
spaces (for example: 00000000 00000001 00000002…).
1.
Discovering devices
There are two methods to discover devices:
Method 1:
Auto Discover
Click DISCOVER, and then enter the PIN code in the Discovery PIN Code box, click the “Discover” button to start searching for devices. The
discovered devices will be displayed in the Discovered list and shown in the DEVICE LIST. Finally, click the “Stop” button to stop searching.
Method 2:
Discover by IP
Enter the PIN code in the Discovery PIN Code box, select “Limit IP Range” and enter the IP address range with “Start Address” and “End
Address”. Click the “Discover” button to start searching. The discovered devices will be displayed in the Discovered list and shown in the
DEVICE LIST. Finally, click the “Stop” button to stop searching.
Note:
“Start Address” and “End Address” must be in the same Network segment. (The subnet mask is 255.255.255.0.)
