Harman® • Accentra52i-TC Installation Manual_R8 • 2017 -___ • 01/19
25
3-90-00584i
A small clearance of about 1/16” is an ideal space between
the legs of the ash lip and the hearth. This cast ash lip is a
decorative part that does not and should not support any
weight.
Note:
There are 2 Tek screws located in the ash lip
rail that can be loosened for adjustment. Figure 5.21.
Magnet
Figure 5.20
Install and adjust the side panel magnets onto the cast iron
ash lip.
In the hardware pack are (2) magnets and (2) 8-32 x 3/4”
bolts and nuts.
Note:
Bolt head should be on the upper side
of the ash lip.
Bolt the magnets through the holes provided in the cast ash
lip. Figure 5.20.
Check the fit of the cast ash lip to make sure that it can be
slid in and out easily. The cast ash lip can remain in place
at this time.
Place the side door on the bottom hinge and insert the top
hinge into the top hole on the side door. Figure 5.17.
Figure 5.17
Bottom Hinge
Top Hinge
Lift the top hinge slightly and slide the bottom of the top hinge
behind the large washer on the center bolt. Figure 5.18.
Figure 5.18
Slide top hinge
behind washer
Install the top bolt and washer on the top hinge. Finger
tighten all 3 bolts that secure hinges to cage frame.
Close the side door and note the alignment of the door. If
adjustment needs made, insert and turn adjusting tool 45
degrees in the slot, Figure 5.19.
If the top of the door is positioned away from the unit and the
bottom is in towards the unit, adjust the top hinge toward the
center of the stove and adjust the bottom hinge away from
the center of the stove. If it is narrow at the top, it needs to
be pushed away from the center of the stove. Figure 5.19.
Adjust lower hinge in similar fashion.
Remove adjustment tool, close door, check alignment to
load door and gap width for consistency.
Figure 5.19
Repeat steps if necessary to fine tune alignment. It is best
to “split” the adjustments between the top and bottom hinge
if possible. Example - you will adjust the top hinge half the
distance and the bottom hinge the other half to achieve
alignment. This will ensure the best alignment of the hinges
and will allow the door to open and close more smoothly.
