Harman® • Accentra52i-TC Installation Manual_R8 • 2017 -___ • 01/19
4
3-90-00584i
A. Appliance Certification
B. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact
your dealer for replacement glass.
C. Mobile Home Approved
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home using a minimum
of 8 AWG copper solid or stranded, insulated or bare wire
or equivalent
and use only listed pellet vent, Class “PL”
connector pipe.
A Harman® Outside Air Kit must be installed in a mobile
home installation.
NOTE:
This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E1509-12, ULC-S628-93
&
(UM) 84-HUD
MODEL:
Accentra52i-TC Pellet Insert
LABORATORY:
OMNI Test Laboratories, Inc
REPORT NO.
0135PN031E
TYPE:
Pellet Fueled Insert/Supplementary
For Residential Use
STANDARD(s):
ASTM E 2779-10, ASTM E 2515-11,
ASTM E 1509-12, ULC-S628-93
D. BTU & Efficiency Specifications
1
Product Specific and Important Safety Information
The
Accentra52i-TC Pellet Insert is certified
to comply with 2020 EPA particulate emission
standards.
T H E S T R U C T U R A L I N T E G R I T Y O F T H E
MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
CAUTION
!
DO NOT INSTALL IN SLEEPING ROOM.
WARNING
!
* Weighted average LHV efficiency using data collected
during EPA emissions test.
**Weighted average HHV efficiency using data collected
during EPA emissions test.
***A range of BTU outputs based on EPA Default Efficiency
and the burn rates from the low and high EPA tests.
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from
a pound of pellets.
This wood heater has a manufacturer-set minimum low burn
rate that must not be altered. It is against federal regulations
to alter this setting or otherwise operate this wood heater
in a manner inconsistent with operating instructions in this
manual.
This wood heater needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood heater in a manner inconsistent with operating
instructions in this manual.
EPA Certification Number:
84-17
EPA Certified Emissions:
1.1 g/hr
*LHV Tested Efficiency:
81.3%
**HHV Tested Efficiency:
76.1%
***EPA BTU Output:
7,400 - 39,700
****BTU Input
11,200 - 50,300
Vent Size:
4 Inch
Hopper Capacity:
64.5 lbs
Fuel
Wood Pellet
Note:
This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E 1509-2012, ULC S628-93, (UM) 84-HUD
Note:
Hearth & Home Technologies, manufacturer of this
appliance, reserves the right to alter its products, their
specifications and/or price without notice.
Harman
®
is a registered trademark of Hearth & Home
Technologies.
Note:
Some generator or battery back-up systems may
not be compatible with the micro-processor electronics
on this appliance. Please consult the power supply
manufacturer for compatible systems.
