Harman® • Accentra52i-TC Installation Manual_R8 • 2017 -___ • 01/19
26
3-90-00584i
E. Reminders
Always disconnect the power cord before the unit is
pulled from the mounting frame.
As you can see, the control board is easily accessible from
the rear with the body pulled out of the frame, even if it is
only pulled out several inches. Figure 23.
Always inspect the wiring harness and the 11 pin socket
(large white flat plug where all of the power wires terminate.)
Always inspect the wiring harness where the wires transfer
from the control to the rear inside of the body.
Make sure there are no worn or frayed areas.
Do not allow pellets or sawdust to build up on the hopper
lip. Figure 24.
Inspect the hopper lid gasket for damage. A good hopper
lid seal is very important for proper operation.
Note:
On models with porcelain finish, there may be some
cases where the cast side panels come in contact with the cast
wings. There are (4) #10 screws and flat washers located on
the hinge plates that can be used for adjustment. The washers
can be removed to allow for less travel. Figure 5.22.
Figure 5.21
Make sure door gap is even on both sides
Adjustment Tek screws
#10 Washer
Figure 5.22
Figure 5.23
Hopper lid foam
gasket
Cast Top
Figure 5.24
