Hardy Process Solutions HI 6600-EIP, Руководство пользователя

Страница: 125 / 137

HI 6600 Series Modular Sensor System User Guide
Page | 125

4: WRITE NONVOL CMD . Write a #4 to the command register to save parameters in non-volatile
memory.
o
No Error Codes

5: CMD : Reserved
o
No Error Codes

6: WEIGHT SAMPLE CMD: Write a #6 to the command register to run the Weigh
Sample command to set up the calibration of the Counts (if enabled).
o Status Error code 1 (motion)
o
Status error code 2 (A/D error)
•
0x64 (100 decimal): CAL LOW CMD . Write a 0x64 hex to the command register to perform the
low step of a traditional calibration. The status register will read 0 if this command succeeds:
o
Calibration_Fail 1
o
Calibration_Fail_Motion 3
o
Calibration_Fail_Adc_Error 4
•
0x65 (101decimal): CAL HIGH CMD . Write a 0x65 hex to the command register to perform the
high step of a traditional calibration.
o
Calibration_Fail 1
o
Calibration_Fail_Motion 3
o
Calibration_Fail_Adc_Error 4
o
HardcalFailCounts 8: not enough counts between hard cal hi and hard cal lo
•
0x66 (102 decimal): C2 CAL CMD . Write a 0x66 hex to the command register to perform a C2
calibration.
o
Calibration_Fail 1
o Calibration_Fail_Motion 3
o
Calibration_Fail_Adc_Error 4
o Calibration_Fail_Noc2 5
o
Calibration_Fail_C2capeq 6
o Calibration_Fail_C2clones 7
•
0x1000 (4096 decimal): WRITE INTEGER CMD. Set the value of an integer parameter.
Write 0x1000 in the command register 0, the parameter ID number in registers 2, 3 and the
desired value in registers 4, 5.
o
No Error Codes
•
0x1001 (4097 decimal): WRITE FLOAT CMD. Set the value of a floating point parameter.
Write 0x1001 in the command register 0, the parameter ID number in registers 2, 3 and the
desired float value in registers 4, 5.
• Failure 1
• TooHigh -1 : value is above legal limit
• TooLow -2 : value is below legal limit
• ErrorNotFound 0x8000 : parameter id not found