Hardy Process Solutions HI 6600-EIP, Руководство пользователя

Страница: 89 / 137

HI 6600 Series Modular Sensor System User Guide
Page | 89
Chapter 8
Troubleshooting
• • • • • •
Chapter 8 provides procedures for troubleshooting the electrical, mechanical and firmware elements of the HI 6600 series
instrument and for using Hardy’s Integrated Technician (IT®) software utility to isolate problems. Flow charts provide
troubleshooting procedures for the Gateway Module, the WPM modules, load cells, and cabling.
NOTE Never run Hardy’s Integrated Technician testing while in a production mode. The reported
weight readings will not be correct and can cause equipment to start or stop unpredictably.
Assembly Notes, Warnings & Cautions
Always disconnect the power cord before disassembling.

Always replace broken or damaged modules or hardware immediately.

Always check to be sure that no loose parts are sitting on printed circuit boards or electrical connectors or wires
when disassembling or reassembling.

Always protect printed circuit boards from electrostatic discharge (ESD). Always use approved ESD wrist straps
and anti-static pads.
AVERTISSEMENT – Risque d’explosion – Ne pas déconnecter l’équipement à
moins que la source d’alimentation ait été mise en position « éteint » ou que la
zone soit classifiée non dangereuse.
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT
UNLESS POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE
NON-HAZARDOUS
AVERTISSEMENT – Risque d’explosion- Ne pas remplacer les composants à
moins que la source d’alimentation soit éteinte ou que la zone est classifiée non
dangereuse.
WARNING - EXPLOSION HAZARD - DO NOT REPLACE COMPONENTS
UNLESS POWER HAS BEEN SWITCHED OFF OR AREA IS KNOWN TO BE NON-
HAZARDOUS.