Electrical installation of charging station
DANGER!
Danger to life due to electric shock!
Before working with the cPµ1 charging station:
Disconnect the electrical power supply and make sure that it stays
disconnected non-stop through the whole installing process.
After completion of the mechanical installation the charging station will be connected
to the power line. In the following, instructions on how to connect additional
accessories are now shown in this manual as it focuses on the basic installation
process. You can find instructions for the accessories in separate manuals of the
respective component.
For the electrical installation, the following tools will be needed:
•
A slotted screwdriver with maximum width of 4 mm (not included in scope of
delivery)
•
A Torx screwdriver or Torx-Bit TX20 (not included in scope of delivery)
•
Stripping tongs
In order to connect your charging station to the power line, please proceed as
follows:
1.
Once again make sure that all circuit breakers and all fault-current-circuit
breakers in the lead are
deactivated
.
2.
Take off the cover of the housing by unscrewing the four screws in the
corners. Then unplug of the LED-Display.
3.
Insert the lead from above into the respective cable gland
s. Clamp the stripped
cores of the lead into the lead terminal blocks according to the labels (see
photo on page 18).
Instruction Manual
cPµ1
charging station
Version: 1.3.5
16