Hardi RANGER PRO VH, Оригинальная инструкция

Страница: 74 / 166

4 - Sprayer Setup
70
Turning the Wheel Rim
Track width can be altered by turning the rims.
After turning the rim around in both sides of the sprayer, new track
width can be read in the table below.
Counter Weight
To improve stability on articulated models, extra weight can be added
by means of liquid-filled tyres.
The standard tyre valve is an universal air-water valve. The tyres may be
filled with liquid to max. 75% of their total volume.
Use a mixture of water and CaCl
2
(calcium chloride) to avoid frost
damage as described below:
200 g CaCl
2
per litre of water gives protection to -15 °C.
300 g CaCl
2
per litre of water gives protection to -25 °C.
435 g CaCl
2
per litre of water gives protection to -35 °C.
Filling the Tyres
1. Jack up the wheel and rotate wheel till the valve is positioned at
“12 o’clock”.
2. Remove the valve body and fill liquid, until it reaches the valve.
3. When surplus liquid is drained through the valve stem, fit the valve
body again.
4. Adjust tyre pressure and lower the wheel. Please refer to “Tyre
Pressure” on page 162.
€
DANGER! It is very important that the CaCl
2
is added to the water and agitated, until it is fully dissolved. Never pour
water on to CaCl
2
! If you get CaCl
2
in your eyes, flush instantly with cold water for at least 5 minutes and seek medical
advice afterwards.
±
WARNING! The tyres must be liquid filled to max. 75 % of total tyre volume. Fill only the quantity. of liquid necessary
to obtain sufficient stability of the sprayer. Do not fill liquid and CaCl
2
mixture in tyres without tubes!
μ
ATTENTION! When filling the tyres, the valve should be positioned at 12 o’clock, and when adjusting the tyre pressure
the valve should be positioned at 6 o’clock.
Rim size Wheel bolts Track width increases by
270/95 R38 8 pcs. 322 mm
380/85 R34 8 pcs. 330 mm