Hardi COMMANDER 4500, Инструкция

Страница: 108 / 170

6 - Maintenance
106
50 Hours Service - Greasing the Pump
When operating the pump, it must be greased every 50 hours with 30
grams of grease into each lubrication point.
˜
ATTENTION! In order to avoid excessive wear, it is important to
use a recommended lubricant (i.e. HARDI® part no. 28164600).
See “Recommended Lubricants” on page 95 for more
information.
˜
ATTENTION! The pump MUST be stopped during greasing!
50 Hours Service - Wheel Nuts
Tighten wheel nuts as follows:
Mounting wheel hub to rim plate: Torque 360 Ft/lb (490 Nm).
Tightening sequence: See illustration and tighten in the order of
numbering.
50 Hours Service - Tire Pressure
Check the tire pressure according to the table in “Tire Pressure” on
page 149.
€
DANGER! Never inflate tires more than to the pressure specified
in the table. Over-inflated tires can explode and cause severe
injuries! See the section “Occasional Maintenance - Change of
Tires”.
±
WARNING! If renewing tires, always use tires with minimum load
index as specified.