HAPP 40
© 2013 HAPP Australia Pty Ltd
Version 8
15
|
P a g e
engagement. After raising the lift briefly, stop and check the adaptors for secure
contact.
1. Push and hold GREEN button until lift reach desired height.
Lift stops once button is released
Vehicle in Raised Position
1. Observe all accident prevention regulations.
2. Do not allow unauthorized persons to stay under the raised vehicle.
3. Avoid rocking of vehicle.
4. Keep lift free of tools, parts, etc
.
5. Fasten the vehicle to the support arms using lashing straps when removing or
installing heavy components
Set on Locks
Use the Unloading Handle to set the lift on the mechanical locks.
In this way the
vehicle
can be securely fixed when the vehicle is in a raised position.
Lowering
Raising and lowering cycles: Closely watching the vehicle and the lift, do not allow
anyone to stay in lift area and make sure the vehicle doors are closed
•
Remove tools, stands or other objects from lift bay.
•
Lift is ready for operation
•
If the safety plate is in the engaged position, briefly raising the lift before
lowering.
•
Pull the unlocking steel wire on both columns
•
Press the Unloading Handle until lift reaches desired height
•
Lift stops once Relief Handle is released or downward travel limit is
reached. During lowering cycles the support arm automatically stop at a
height of 110mm.
•
To lower the arm completely, please release the Unloading Handle.
Swing arms to full drive-through position and drive the Vehicle off the lift
In case of motor defect or power failure the lift can be lowered manually.
Authorized personnel only! Do not restart the lift before the error has been remedied.
If the lift load lies fully on the safety plates, manual lowering is not possible.
