41
- Input Compensation : When the product is shipped, it is adjusted to precision with error margin
within 0.1 %. However, in case of imprecision during simultaneous use
with other instruments, the input temperature can be increased/decreased by
force within the range of ±100 ℃.
- Filter Setup : If severe noise is present in the sensor signal system, and measured values are
inconsistent, then suitable filtering time should be set.
(Higher this value, the prompt control become difficult).
- Control Mode : Heating control, heating/cooling control selection
- Control output type : SCR, SSR, RELAY Selection.
(When relay is selected, relay number selection box is activated).
- Anti Reset Wind-up : Range setup to prevent overloading.
(Setup in P-BAND Percentage)
- Output Frequency : If control ouput type is SSR or RELAY (PID Control), PID control will
be carried out in time ratio. Setup output frequency at this time.
(Shorter the frequency, control performance is better, but can stress relay etc.
Recommend SSR usage)
- ON/OFF Control Irresponsiveness : At ON/OFF control, setup output switch Irresponsiveness. If
irresponsiveness is high, the control performance degrades,
low irresponsiveness stresses the relay etc through frequent
6.2 Control/Transmission Setup
هﺮﮐ
ﮓﻧﺎﯿﻧﺎﻫ
تﻻﻮﺼﺤﻣ
یرﺎﺼﺤﻧا
هﺪﻨﯾﺎﻧﻤ
ناﻮﯿﺳ
ﺖﮐﴍ
021-33989001
www.sivancarno.com
021-33989002
