38
Basically, although the program executes the segments in the corresponding pattern sequentially, at
times the particular segments are set in the pattern repeatedly. At these times, if the part-repeat
functionality is used, the program input can be minimized. The part-repeat loop in the pattern can be
set at maximum, 20. If part repeat is not set, the segments inputted in the patterns are sequentially
executed, and if the loop is set, then the execution starts at segment 1, until the segment number for
the first loop is encountered, the loop is executed. Afterwards, when the last loop is complete, the
program is executed from the next segment number until the last segment of the pattern.
- Pattern Repeat : Setup number of pattern
repeats. Default : 1
- Connect Pattern : Number for the pattern
for connection. (If 0, no connect operation)
Press [REPEAT/CONNECT] button on the program setup screen to enter the REPEAT/CONNECT
setup screen.
5.3.3 Repeat Pattern/Connection Setup
Press [STANDBY MODE] in the program setup screen to enter the standby setup screen.
In the case where 'standby' is activated for each
segments of corresponding pattern, the range for
which 'standby' is to be applied and the maximum
time for 'standby' is setup.
When the 'standby' mode is activated, check whether PV had come into the 'standby' range at the
time of segment change, and if the 'standby' range is not entered, it'll wait until the maximum time for
'standby' is expired. When the maximum 'standby' time is expired, it goes over to the next segment by
force. (When 0 is set, 'standby' without time limit).
5.3.4 Standby Mode Setup
هﺮﮐ
ﮓﻧﺎﯿﻧﺎﻫ
تﻻﻮﺼﺤﻣ
یرﺎﺼﺤﻧا
هﺪﻨﯾﺎﻧﻤ
ناﻮﯿﺳ
ﺖﮐﴍ
021-33989001
www.sivancarno.com
021-33989002
