![background image](http://html2.mh-extra.com/html/hantle/t4000/t4000_operators-manual_3703919029.webp)
Section 3: Programming
Operator Manual
T
4000™
(Rev 1)
© Hantle 2010
3.11
RMS PASSWORD
Remote monitoring is protected by a password that is checked when incoming calls
from RMS occur. If the password does not match from an incoming RMS call, the call
will be disconnected. The default password for RMS access is 333333. To change the
password, press the password button and you will be prompted to enter your Master
password. After entering your Master password, you will be prompted to enter the
new RMS password (must be 6 digits) and then enter it again for verification. If you
ever forget the RMS password, press password and follow the procedure again.
REMOTE PHONE #1, #2
This is the number the ATM will
call if there is an out of service
condition. Press the button for
either number and enter the
number for the computer you want
the ATM to call.
Using the numbers on the keypad
press the first number of your
phone number. You can use the <,
> keys on the keypad to move
back and forth (to correct any
mistakes, or edit existing
numbers).
RING COUNT
This setting determines how many rings will elapse before the ATM will answer the
phone. While this can be used in situations where the ATM phone line is shared with
an additional device (like a fax or business phone) it’s important to note that setting
this value higher than 4 or 5 may result in monitoring software being unable to
connect.
3.2.8 TRIAL DAY TOTAL
Trial Day Total feature allows the ATM to complete a Day Total operation (without
actually closing out the machine) at a predetermined time each day. This is useful if
you are doing accounting of your ATM on a day-to-day basis. Your processor cuts off
its transactions each day at a set time. By enabling Trial Day Total at the same
time, your day’s balance should match the host. This information will appear as a
journal record, so you will need to access your journal to print or view the totals.
Your dealer or processor can provide you with the appropriate cut off time.
Trial Day Total Set Enables or Disables the function
Change Time
Sets the time for the ATM to total itself
Содержание T4000
Страница 1: ...Operator Manual Hantle T4000 Hantle Inc...