![background image](http://html2.mh-extra.com/html/hantle/t4000/t4000_operators-manual_3703919013.webp)
Section 2: Installation
Operator Manual
T
4000™
(Rev 1)
© Hantle 2010
2.3
2.1.2 PHYSICAL INSTALLATION
IMPORTANT NOTE
: Before planning any install, please be careful to follow ADA
guidelines for height and reach access. Diagrams in this section represent a
theoretical installation with unobstructed forward and parallel access. Specifics for
ADA guidelines can be found at www.access-board.gov
Step 1
Begin by preparing the hole in the wall. Refer to
the diagram at right for dimensions. The wall
will not be carrying the weight of the machine.
If the wall is thinner than 4” in thickness, you’ll
need to construct a backfill to make up the
distance.
NOTE:
Hole diagram spec provides extra .25” for
clearance on each side.
Step 2
When planning your installation, remember to
compensate for height differences between the
exterior floor and the interior. Pedestal height
allows for 25 to 35 inches overall (+1~2” if
pedestal feet are used).
Set the pedestal height to just above the
bottom of the hole (the
T
4000
™
outside bezel,
when installed, extends below the bottom by
½”).
Position the base as close to the wall as
possible. The holes on top of the pedestal are
elongated to give you several inches of
horizontal movement. You want the pedestal
as close to the back side of the wall as
possible.
Содержание T4000
Страница 1: ...Operator Manual Hantle T4000 Hantle Inc...