24
INST
ALLA
TION
Panel-Mount Hardware
Label Description
Quantity
1
Process controller
1 pc.
2
External gasket
1 pc.
3
Panel bracket, 100 mm (3.93”) long
2 pcs.
4
M4 x 45 mm screw (DIN 7985)
4 pcs.
5
Plain washer for M6 screw
4 pcs.
6
Spring washer for M6 screw
4 pcs.
7
M6 x 12 mm screw (DIN 7985)
4 pcs.
To mount the controller on a panel:
1. Select the position desired for the controller on the panel, and make the cutout following
dimensions indicated in
Figure 10
. Smooth the cutout edges so as not to damage the gasket or
to scratch the controller during assembly.
2. Unscrew all six M20 cable glands using an M24 socket or wrench (
Figure 12
, part A).
3. Keep the venting element (
Figure 2
, label 2) in position.
4. Slide the gasket onto the controller and place controller into panel cutout from the front of the
panel.
5. Using screws and washers, screw the brackets to the controller from back side. Screw M6 x12
mm screws into bracket and tighten against the back of the panel.
6. Screw the six cable glands (
Figure 12
, part B) back in place.
7. Connect the protective ground wires (
Figure 12
, part C).
(A)
(B)
Panel bracket
Protective ground connection screws
(C)
Figure 12:
Panel-Mount Steps, Parts (A) ( B) (C)
