
Hampton® H35-10 Direct Vent Freestanding Gas Stove
|
45
45
|
maintenance
12)
Carefully lift the burner tray assembly out of
the unit to remove.
13)
Replace with new valve assembly and reverse
steps to reinstall. .
To remove valve from valve assembly, continue.
14)
Disconnect the red, green and yellow wires
from the stepper motor as shown in the picture
REMOVING VALVE
If your valve requires maintenance or replacement,
use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1)
If optional fan is installed, disconnect power
source to stove.
2)
Open the access panel and remove the valve
cover plate.
3)
Disconnect gas line to stove.
4)
Disconnect 3/8" NPT pipe from 90
o
elbow on
valve.
5)
Disconnect the two (2) switch wires from valve.
6)
Lift off the Cast Top and lift out the front door.
7)
Remove the cast front. (See page 13 for instruc-
tions).
8)
Remove the glass front assembly by opening
the the 2 latches.
9
) Carefully remove the logs, embers and rockwool.
10)
Remove burner (see diagram below).
Note:
Use a magnetic type screwdriver if possible.
11)
Remove all 18 screws holding the burner tray
assembly in place.
INSTALLING VALVE
ASSEMBLY
1)
To install a new valve assembly, reverse instruc-
tions for
removing valve
. See assembly steps
1-11.
2)
Check for leaks and manifold pressure. See
Gas Pressure Test
instructions.
3)
To reinstall valve, reverse instructions for remov-
ing valve assembly, steps 14-20.
Disconnect the ignition wires from IFC,
connected to the valve
15)
Remove two (2) ignition cables from the IFC.
16)
Remove pilot nut with an 11 mm wrench.
17)
Remove valve to orifice nut with a 13/16"
wrench.
18)
Remove inlet pipe with pipe wrench. Note
orientation of 90
o
elbow.
19)
Remove two (2) phillips head M5 screws on
each side of the valve.
20)
Remove valve and remove gas out 90
o
brass
fitting. Note orientation of fitting.