34
|
Hampton® H35-10 Direct Vent Freestanding Gas Stove
|
34
installation
Access Panel
BACK UP
BATTERY INSTALL
1.
Open the access panel of the unit.
2. Unscrew the 2 screws (1 on each side), from
the Valve Cover Plate.
3. Take the valve cover plate out.
4. There will be the battery compartment sitting
in the front.
NOTE:
Remove the batteries when normal operation
is resumed as the heat will drain the bat
-
tery power rapidly.
OPTIONAL
BRICK PANEL
1)
Remove the front cast. (See page 13 for
instructions) and glass front (see page 41 for
Glass Replacement instructions).
2)
Remove the log set if installed.
3)
Insert the back brick panel first by carefully
slipping it between the back wall of the firebox
and the rear log bracket.
Back Panel
Diagram 1
4)
Before installing the side brick panels, loosen
the screws for the brick tabs enough so that you
can slide the brick tabs on to the screws easily
but that the tabs are secure. For the location
of the side brick tab screws see Diagram 1.
5)
Put the side panels in next. Slide them in from
the front and push them flat up against the
wall. Be very careful not to scratch them on
the firebox hardware.
Brick
tab screw
Back
brick
panel
Side
brick
panel
Diagram 2
6)
Install the brick tabs (refer to Diagram 2).
Left
Side
Panel
Right
Side
Panel
Brick Tab
Screw
Brick
Tab
Valve Cover Plate
Screw 2
Screw 1
4. Install 4 AA batteries into the box and slide it
back to its original place.
5. Reverse steps 3-1 to reinstall.
