HAMPTON BAY H35-10, Инструкция для владельца и по установке

Страница: 35 / 52

Hampton® H35-10 Direct Vent Freestanding Gas Stove
| 35
35
|
installation
LOG SET
INSTALLATION
Read the instructions below carefully and refer
to the diagrams. If logs are broken do not use
the unit until they are replaced. Broken logs can
interfere with the pilot operation.
The gas log kit contains the following:
a) 02-43 Rear Log
b) 02-56 Middle Left Log
c) 02-44 Front Left Log
d) 02-46 Left Top Log
e)
02-45 Front Right Log
f) 02-47 Center Log
g) 02-48 Middle Right Log
h) Embers
i) Lava
j)
Platinum Embers
(supplied with
packaged manual)
The "02" refer numbers (i.e. 02-43) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle with
care - do not force into position.
2) Lift off the Cast Top and remove the glass front
(refer to the "Glass Replacement" section in this
manual).
3) Sprinkle the embers on the left and right sides
of the firebox base.
A) 02-43 D) 02-46
G) 02-48
C) 02-44 B) 02-56
F) 02-47
E) 02-45
Embers Embers
C)02-44
Pins on Rear Log Support
A)02-43
B)02-56
4) Place Rear Log A)02-43 on the two pins on the
rear log support.
5)
Place the Middle Left Log B)02-56 on the two
pins as shown.
6)
Sprinkle some lava rock just in front of B)
02-56 on the burner holes.
7) Place Front Left Log C)02-44 onto the 2 front
pins as shown.
8) Place the Left Top Log D)02-46 on the pin
on Log B)02-56 and on top of the cutout
on Log A)02-43.
E)02-45
Cutout Pin
D)02-46
B)02-56
A)02-43
C)02-44
9) Place Front Right Log E)02-45 on the two
pins as shown.
10) Place the lava rock in the area between
the left and right logs, leaving a space in
the middle for log (F) 02-47.
Separate platinum embers and place on
and around the lava rock. Avoid stacking
platinum embers.
Cutout
Notch
F)02-47
E)02-45
A)02-43
11)
Place the notch in Center Log F)02-47 over
Log E)02-45 and across the cutout on Log
A)02-43.
lava rock
B)02-56
Notch
A)02-43
G)02-48
E)02-45
F)02-47
12) Position notch in Front Right Log G)02-48 on
Log F)02-47 and push the bottom right edge
against the bracket on the burner tray.