Page 82
d. Strip the ends of the red, green, and black wires so that
the special connectors (in envelope) may be attached, i.e.,
clamped and soldered, as follows:
• Red wire - male connector
• Green wire - female connector
• Black wire - female connector.
e. Disconnect the green wire (from the amplifier) at the
speaker terminal and fit the plastic insulating sleeve over it.
Connect this green wire to the red adapter wire by means
of the special connector. Pull the plastic sleeve over the
connection.
f. Connect the green adapter wire to the speaker terminal just
vacated by the green wire.
g. A second speaker operates in parallel with the speaker
mentioned in Step
e.
The black adapter wire is to be
connected to this “second speaker” at the same terminal
to which the black wire from the other speaker is already
connected.
h. Connect the blue and grey adapter wires to the two AC
terminals on the console amplifier which are under the
control of the console power switch.
i. The 6-conductor connecting cable is supplied in a standard
30-foot length complete with plug and socket. This is
Leslie Part No. 727. For longer console-to-speaker runs,
two or more of these standard 30-foot assemblies may be
connected together in series.
Figure 7–2: Leslie 6W Connector Pin-Out
7–3 OTHER RESOURCES
At the time of this writing, the following resources contain a
number of terrific modifications.
•
Hammond Wiki — Hammond Modifications page:
http://www.dairiki.org/HammondWiki/
HammondModifications
•
Captain Foldback — Great source of Hammond information
http://www.captain-foldback.com/
7–4 REVISED RH END-PANEL LAYOUT TEMPLATE
The drilling template shown in
Figure 7–3
is designed to add the
following modifications in a clean and almost factory-original way:
•
Kon Zissis’ Chorus Depth Control
•
Kon Zissis’ Treble Boost
•
Kon Zissis’ Overdrive (documentation missing)
•
Line Out as described in
7–2
Содержание L-100 Series
