Hamamatsu Photonics LIGHTINGCURE LC8, Инструкция по эксплуатации

Страница: 22 / 56

22
Outline
This light source equipment irradiates the light which can be applied to any place as desired.
This equipment uses a mercury xenon lamp (or xenon lamp) made by Hamamatsu Photonics. The light from the
lamp is collected by the converging mirror and lead by the light guide to any desired place for irradiation.
The unit consists of the optical system including a lamp, mirror, shutter and diaphragm, power source and con-
trol system to cause the lamp to turn on and these components are arranged effectively in the compact frame.
Using with a light guide of wide variation and optical system (option) in combination, this unit can be used
for various applications. Also, it is possible to turn the lamp on/off, open/close the shutter and control the dia-
phragm from outside.
Installation
●
For installation, avoid a place with high temperature or humidity. (Recommended environment for use:
About +25 °C ambient temperature, 80 % or less humidity)
●
Allow for adequate ventilation of fan exhaust.
●
Some lamps, depending on types, produce ozone which smells for some time after they are turned on. Al-
though ozone is not produced so much as to affect a person bodily, be sure to ventilate the room from time
to time when using the lamp in the closed room for a long time.
●
Set the unit horizontally on a level surface.
●
The fan exhaust outlet at the rear of the unit must be at least 10 cm from the wall.
When placing the unit in a closed space, be sure to force exhaust by using an exhaust duct or the like. In
such case, arrange installation so that the air flow from the fan exhaust outlet and the hot air temperature
are the same as those when the unit is installed in an open space.
●
The air inlets on the left and right sides of the unit must be at least 10 cm from the wall.
Installation of L9566
At least
10 cm
At least
10 cm
Air Inlet Air Inlet
At least
10 cm
At least
10 cm
Caution
Intake Intake
Exhaust
Exhaust
Installation of L9588