Hamamatsu Photonics LIGHTINGCURE LC8, Инструкция по эксплуатации

Страница: 21 / 56

21
High temperature warning label
(inside of cover)
These labels must be attached so that they are
clearly visible all the time.
If they come off or become dirty, replace them
with new ones.
Warning labels are available (chargeable) from
our sales office. (Refer to page 56.)
When it becomes necessary to replace any
warning label, contact the nearby sales office.
1-3. Warning Label Positions
●
Top View
●
Vibration and Impacts
Handle the unit with care. Sharp impact or strong vibra-
tion can break the lamp or other fragile components, or
disrupt the precise adjustment of internal mechanisms.
●
Abnormal Condition
Should an abnormal condition is found such as smoking,
abnormal smell or noise, turn off the power immediately
and then disconnect the AC cable from the AC outlet.
The continuous use of equipment with any abnormal con-
dition may cause a fire, electric shock and other troubles.
●
Power Connection
To prevent electrical shock, always ground this unit using
the grounding terminal of the power cord.
Make sure that the power voltage in use complies with
specification. Using the equipment at any other voltage
may cause a fire, electric shock and other troubles.
●
Lamp Replacement
Replace the lamp when operating time will be over 4000
hours (L8253:3000 hours). The average service life of the
lamp is 4000 hours (L8253:3000 hours). Lamps may burst
if used for longer than 4000 hours (L8253:3000 hours).
●
Disposal
Main unit
This product, when to be disposed of, should be treated prop-
erly according to the waste disposal law by the user or by
the industrial waste treatment firm duly authorized. When it is
used and disposed of in any place outside of Japan, it should
be treated properly according to the statutory regulations of
the state and local governments applicable to that place.
Lamp
This product contains highly pressurized xenon gas (about 0.1
MPa to 1 MPa) and mercury sealed in. This product, when to be
disposed of, should be treated properly according to the waste
disposal law by the user. Or it should be handed over to the indus-
trial waste treatment firm duly authorized as it is (without breaking
it) because it has high inner pressure for proper disposal there.
When it is used and disposed of in any place outside of Japan, it
should be treated properly according to the statutory regulations
of the state and local governments applicable to that place.
●
Intended main purpose
Ultraviolet curing, drying, hardening etc. This product is
not suitable for household room illumination.
CAUTION
Note that this equipment is classified as a product in IEC Standard
Class I. In order that this equipment is used properly and safely, be
sure to observe safety precautions described in the following pages.
Use of this equipment in any way other than that described in this
manual may hinder the protection function of this equipment. HAMA-
MATSU PHOTONICS shall not be liable for any faulty condition caused
by such use against any of the said precautions.
■
The symbol marks used for this equipment and their mean-
ings are as follows.
“Handle with care”. This symbol is found where User’s
Manual or Service Manual should be referred to in order to
protect the operator and the equipment.
Protective grounding terminal
Alternative current
ON OFF
(Power supply) (Power supply)
●
Inside of Lamp Cover
Warning label
Warning label
L9566/L9588- 03, 04, 06A
L9566/L9588- 01A, 02A