Haier HAVG9WL38WPB, Инструкция по использованию, Страница: 12 / 256

12 12
F
F
F
F
R
R
R
F
F
R
R
Fig. 1.2a
G
G1
G2
Fig. 1.2b
FASTENING THE COOKTOP
Each cooktop is provided with an installation kit
including brackets and screws for fastening the
cooktop to benches from 30 to 40mm thick.
The kit includes four “
F ” type brackets (for the
front of the cooktop), three “ R ” type brackets (for
the rear of the cooktop) and seven self-threading
screws “ S ”.
• Cut the unit according to the dimensions in
fig. 1.1a or 1.1b.
• Stretch gasket “ G ” over the edge of the hole
made, being careful to overlay the junction
edges (fig. 1.2b).
• Fasten the brackets “ F ” and “ R ” to the
appropriate socket holes, without tightening
the screws “ S ” for the moment. Make sure
that the tabs are mounted correctly, as
shown (figs. 1.2c, 1.2d). Rotate the tabs so
that the cooktop can be put into the cutout.
• Put the cooktop into the cutout and position
it correctly.
• Put the brackets “ F ” and “ R ” into place; tooth
“ A ” of the brackets should go into the hole
(figs. 1.2c, 1.2d).
• Tighten screws “ S ” until the cooktop is
completely secured to the bench.
• Using a sharp cutter or trimmer knife, trim
the excess sealing material around the edge
of the cooktop.
Take care not to damage the workbench.
• In case to install the hob flush with the work
surface, fill any gaps between the glass and
along the perimeter of the work surface with
insulating silicone, and wipe away any excess.
30 mm min. 40 mm max.
S
A
F
G (G2)
30 mm min. 40 mm max.
40 mm min. 40 mm min.
S
A
R
G (G1)
30 mm min. 40 mm max.
S
A
F
G (G2)
30 mm min. 40 mm max.
40 mm min. 40 mm min.
S
A
R
G (G1)
Fig. 1.2c Fig. 1.2d
Rear Fixing Brackets Front Fixing Brackets