Hagie UpFront DTS 8T, Руководство оператора, Страница: 36 / 102

IV.
OPERATING INFORMATION
B. Hydrostatic Drive System
30
Starting the Engine
1. Position hydrostatic control lever to “N” (neutral) position.
2. Put the parking brake switch to the ON position.
3. When starting procedure is complete, return switch to OFF position.
4. Turn key to the “ON” position to check instruments.
5. Turn the ignition key switch to the start position to engage the
starter. If the engine fails to start after 15 seconds, turn the key
OFF, wait one minute and repeat the procedure. If the engine does
not start after three attempts, check the fuel supply system. Ab-
sence of blue or white exhaust smoke during cranking indicates no
fuel is being delivered.
6. When the engine starts, immediately reduce throttle lever setting to
1/3.
7. Inspect indicator lights and gauges for correct operation. If any
lights or gauges do not operate, shut off engine and determine the
cause.
8. Always allow at least a five minute warm-up period before operating
the engine at high RPM. This means the engine must reach operat-
ing temperature and oil pressure must stabilize in the normal oper-
ating range before it is run faster than an idle (1000 RPM or less).
Cold oil may not flow in quantities adequate to prevent pump cavita-
tions.
S t a r t e n g i n e f r o m
operator’s seat only. When
running engine in a
building, be sure there is
adequate ventilation.
NOTE:
Do not use starting fluid
when starting an engine. The
use of too much starting
fluid will cause engine dam-
age.
When using an external
electrical source to start
the engine, turn the
disconnect switch to the
“OFF” position. Remove
the key before attaching
the jumper cables to
preven t un int ent ion al
starter engagement.