Hafco BM-23A, Руководство по эксплуатации

Страница: 22 / 49

22
OPERATION MANUAL
Positioning Headstock
The head tilts 45° forward or backward and
rotates 90° left or right (see Fig. 19, 20 ).
Any time the head has been tilted or rotated,
you must square the spindle with the table
when setting the headstock back to the 90°
position. This is the only way to ensure preci-
sion milling results later.
90 °
Fig. 19
Fig. 20
45 °
Tilting Head Forward/Backward
1. DISCONNECT MACHINE FROM POWER!
2. Loosen three lock bolts “A” shown in Fig.21
3. Use one hand to apply pressure to head in
direction of tilt, then slowly rotate tilt-bolt “B”
shown in Fig. 21
NOTE: Rotate tilt-bolt clockwise to tilt head
backward and counterclockwise to tilt it for-
ward.
4. Re-tighten lock bolts
Fig. 21
Rotating Head Left & Right
1. DISCONNECT MACHINE FROM POWER!
2. Loosen four lock bolts “A” shown in Fig 22, 23
half a turn only.
NOTE:
Do not completely remove the four lock
bolts as the head will fall off and may causew
injury. Check your model number for the posi-
tion of the 4 bolts.
3. Use one hand to apply pressure to head in
direction of rotation, then slowly turn rota
tion bolt “B” shown in Fig. 22 or 23.
NOTE:
Turn rotation bolt clockwise to rotate
head left and counterclockwise to rotate it right.
ADJUSTMENTS
Page 22 Instructions Manual for BM-23A (M595D) 12/02/2018