Hafco BM-23A, Руководство по эксплуатации

Страница: 17 / 49

17
OPERATION MANUAL
Variable Speed Control
Hi Speed: move the handle (Fig 6-1 , A,) on the
front of the top of the head. Move the handle B
(Fig 6-2 B) to the IN position. Rotate the spin-
dle nose by hand until the gears mesh with the
clutch. Move the handle B to the OUT position(
Fig 6-2,B)
Low-Speed:
move the handle A lever from the
top of head, then move the handle B to the IN
position
Fig. 6-1
High-Neutral-Low Shift Lever
The mill head can be driven directly (High Speed)
or through the back gears (Low Speed) in the
mill head. The selection is made by changing the
position of the shift lever.
The shift lever is located at the lower right side of
the mill head (Fig. 8). The lever position closest
to the operator is the High setting. The lever po-
sition away from the operator is the Low setting.
The middle position is the Neutral setting.
Do not shift the High-Low Gear Lever while the
motor is running. Rotate the spindle by hand
while changing the lever
Fig. 6-2
Spindle Brake
The spindle brake lever is located on the upper
left side of the mill head ( A. Fig. 7). Pull lever
downward to apply the brake. The spindle brake
is used only after the motor switch has been set
to OFF. The spindle will not stop with the motor
running.
Fig. 7
Fig. 8
Page 17 Instructions Manual for BM-23A (M595D) 12/02/2018