HAEMMERLIN 312175001, Инструкция по эксплуатации

Страница: 43 / 88

43
Manual tipping upwards:
- Move the tipping handle to gradually tip the skip to empty it. We remind you that to be emptied, the
skip must be unlocked (see detailed image G)
- When the skip is emptied, it must be locked (see detailed image H) by moving the skip lock before
lowering the mobile equipment.
Before doing an empty test, check that the ladder slope is greater than or equal to 30° in relation to the
ground in order to guarantee that the skip returns in good conditions.
Due to the high dynamic forces generated during the upward tip, it must be ensured that the end of the
ladder is well supported. We recommend the use of the pair of headboard props (see page 69). However,
other means are possible, provided that the headboard is well supported and fixed to the building to
prevent the hoist from sliding or tipping over
.
Carry out several empty tests (skip locked) and then loaded tests (skip unlocked):
- assembly of the mobile equipment,
- manual tipping up of the skip,
- return of the skip,
- descent of the mobile equipment,
- manual tipping downwards of the skip.
Also verify that the upper limit switch is working properly.
If necessary, adjust the position of this upper limit switch by moving the clamping handle and the flange
(see chapter entitled “Installing the upper limit switch on the ladder” page 27)
When all of the above points have been checked, the tipping skip is ready for use.