Page 56 of 62
Brushless DC Controller HST-350
Orginal
operating
manual
Rev1.3
Mounting and commissioning
Activating a sensor: The number mentioned under „Script“ must be entered in the „Value“ field,
here using the example of the temperature sensor of the battery:
The Advanced, TECH and GEN tabs can only be customized in cooperation with the correspon-
ding project management at Hacker. Below you will find the setting of the Basic menu, which you
can customize freely. The values are self-explanatory. Since the software of the controller is sub-
ject to a constant extension process, the representation can deviate from the actual version.
After you have successfully written and parameterized the EEPROM, you can now start to put the
system into operation.
To do this, please close the bootloader so that the CAN interface is free for the next step.
To do this, press the [Release] button at the top/left before pulling out the CAN adapter.
Now the controller must be restarted. To do this, disconnect it from the power supply for approx. 10
seconds and then reconnect it.
For further support contact
NOTE
Changing parameters
Changing the parameters requires sound specialist knowledge. Incorrect parameters can
lead to the destruction of the drive and cause consequential damage.