9
Examples
# Disable pausing between screens of output for the current session.
<Sysname> screen-length disable
Related commands
screen-length
super
Use
super
to switch from the current user privilege level to a specified user privilege level.
Syntax
super
[
level
]
Views
User view
Default command level
0: Visit level
Parameters
level
: Specifies a user level in the range of 0 to 3. The default is 3.
Usage guidelines
If a
level
is not specified, the command switches the user privilege level to 3.
There are four user privilege levels: visit (0), monitor (1), system (2), and manage (3). You can assign
different privilege levels to different users. After login, a user can access the commands at or under the
assigned level.
A user can switch to a lower privilege level unconditionally. To switch to a higher privilege level, a user
must enter the switching password. If no password is configured for the level, the switching operation fails
unless the user is a console user. A console user can switch to a higher privilege level when no password
is configured for the level.
With scheme authentication, a user who fails to provide the correct password during five consecutive
attempts must wait 15 minutes before trying again. Trying again before the 15-minute period elapses
restores the wait timer to 15 minutes and restarts the timer.
Examples
# Switch to user privilege level 2 from user privilege level 3.
<Sysname> super 2
User privilege level is 2, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
# Switch back to user privilege level 3. (Suppose the switching password is
123
. If no password is set,
users cannot switch to user privilege level 3.)
<Sysname> super 3
Please input the password to change the privilege level, press CTRL_C to abort.
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
