SCANNER
(OPTIONAL)
77
Setup Simple Scan
Panel operation
1.
Press the Shift key, the 2
ND
key
(MENU), the Left key twice.
The Scan menu appears.
2.
Press the Down key. The Simple
Scan menu appears.
3.
Press the Down key again. The
Starting (Minimum) channel
setting appears.
4.
Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
Range
101 ~ 118, 201 ~ 218
* If the entered value is out of
the range, an error message
appears (Small or Large).
5.
When finished, press the
ENTER key. The End
(Maximum) channel setting
appears.
GDM-8200 Series User Manual
78
6.
Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
Range
101 ~ 118, 201 ~ 218 (must be the same
or bigger than the Start (Min) channel)
7.
When finished, press the
ENTER key. The Timer setting
appears.
8.
Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
Range
1ms ~ 9999ms
9.
Press the ENTER key. The loop
(step) Count setting appears.
10.
Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
Range
1 ~ 128
11.
Press the ENTER key followed
by the EXIT key. The setting is
stored and the display goes back
to the normal mode.